Using the Command-Line Interface

This chapter describes the CLI syntax, conventions, and modes supported in TejNOS-EN system.

TEJOS Modules

This chapter describes the modules supported in the software suite of TejNOS-EN system.

Stacking Commands

This chapter describes the commands to configure stacking of TejNOS-EN system.

Management Commands

This chapter describes the commands to configure the TejNOS-EN system for management access.

Utility Commands

This chapter describes the utility commands to configure the TejNOS-EN system features, components, and configurations.

PoE Commands

This chapter describes the PoE commands available in the TejNOS-EN system.

Switching Commands

This chapter describes the commands to configure switching features supported in the TejNOS-EN system.

Routing Commands

This chapter describes the commands to configure routing features supported in the TejNOS-EN system.

Border Gateway Protocol Commands

This chapter describes the commands to configure Border Gateway Protocol in the TejNOS-EN system.

OSPFv3 Commands

This chapter describes the commands to configure OSPFv3 in the TejNOS-EN system.

IPv6 Commands

This chapter describes the IPv6 commands supported in the TejNOS-EN system.

DHCPv6 Commands

This chapter describes the commands to configure DHCPv6 in the TejNOS-EN system.

Quality of Service Commands

This chapter describes the Quality of Service (QoS) commands supported in the TejNOS-EN system.

Multicast Commands

This chapter describes the commands to configure IP Multicast features in the TejNOS-EN system.

IPv6 Multicast Commands

This chapter describes the commands to configure IPv6 Multicast in the TejNOS-EN system.

TEJOS Log Messages

This chapter lists common log messages that are provided by TejNOS-EN system, along with information regarding the cause of each message.