|
|
|
|
HCPSLine03 card supports 4xSTM-64 interfaces. Following modes are supported in TJ1600 Type-11SR chassis.
The mode(s) supported with HCPXCC03 include:
The mode(s) supported with HCPXCC04 include:
The mode(s) supported with OSMC01 card in TJ1600 Type-11SR and TJ1600 Type-6SR chassis include:
The mode(s) supported with OAMC card in TJ1600 Type-2SR chassis include:
NOTE 1: Ports from P5 to P8 are not supported in this product release.
NOTE 2: With HCPXCC04, fresh card configuration is not supported for modes: SDH GATEWAY Card and SDH FEC CARD.
The following figure shows the front panel view of HCPSLine03 card:
Power Specifications- HCPSLine03
Specification |
Range |
|---|---|
Input Voltage |
-48V DC |
Power consumption |
100W |
The visual indicators on the HCPSLine03 card include two LEDs, the ACTIVE and the STATUS LEDs.
Possible LED status and their significance- HCPSLine03
Card State |
Status LED |
Active LED |
|---|---|---|
Card initialization: State before the card initialize is complete on card insertion. |
Amber (Steady) |
Amber (Steady) |
Card in service: Initialization complete and card in service. |
Green (Steady) |
Green (Steady) |
Card mis-match: Node has already configured the slot with some other card. |
Amber |
Amber |
Card failed during boot up. |
Red |
Amber |
Card failed while in-service. |
Red |
Green |
Improper jack in of the card. |
Green (Blinking) |
Green (Blinking) |
Hard Reset: All devices reset, FPGAs cleared and reprogrammed. Goes to initializing state next. |
Amber |
Amber |
Soft Reset: Software is restarted, devices are reinitialized with provisioning. Goes to initializing state next. |
Green |
Green |
Early Ejector LED status: One ejector is removed (contains one ejector switch in right). |
OFF |
Amber |
XFP Port Transmitter (Tx) and Receiver (Rx) LED Status- HCPSLine03
State |
Rx LED |
Tx LED |
|---|---|---|
XFP present (Laser on) with Rx LOS. |
Amber |
Green |
XFP present (Laser off) with Rx LOS. |
Amber |
Off |
XFP present (Laser on) with no Rx LOS. |
Green |
Green |
XFP present (Laser off) with no Rx LOS. |
Green |
Off |
Card failed while in-service. |
Red |
Green |
XFP missing (LOS detected), Laser On (attempted). |
Amber |
Green |
XFP missing (LOS masked since XFP missing and set to Admin_down), Laser Off (attempted). |
Amber |
Off |
XFP failed (whether provisioned, unprovisioned, LOS or no LOS). |
Red |
Red |
The LASER types supported are as follows:
OPTICAL SAFETY: Do not stare or look directly into the optical connector output beam, as this can cause irreparable damage to your eyes and even loss of eye sight.
HCPSLine03 card processes the received STM-64 frame for all alarms and performance monitoring signals.
HCPSLine03 card supports the following functional features: