Save port editions

Perform the following steps to edit or modify the L2, GPON, and PDH ports:

Go to Configuration > Layer 2 menu and click Ports option. The Manage Ports page is displayed.
Select the desired port from the list in L2 Ports/PDH Ports tab. Use the search option provided on the Ports page to search for a specific port on a node.
The selected port will be displayed in the bottom of the page. Click the parameters desired to edit or modify. Refer the Editable L2 Ports parameters, Editable GPON Ports parameters and Editable PDH Ports parameters table for more information.
Click OK button. The changes done will appear in blue in the upper column against the node selected.
Click (Save Ports) to save the changes.

NOTE: If user does not click Save Ports, the changes done will not be applied on that port.

An error message will get displayed if the editions on a port fails. This might happen due to reasons, some of which are listed as follows:

If the node is not reachable.
Ports/Card Mode is not configured on card at the node level.
If the changes done are conflicting any other feature such as tunnel/service/management channel present on the port.

Editable Manage Ports parameters

Parameter	Description
Label	Displays the port number selected in ci-si-pn format. This parameter cannot be edited.
Type	Allows you to edit the port type as DOT1Q, DEFAULT, DOT1Q_WITH_PRIO, DOT1Q_WITH_DSCP, DOT1AD, DOT1AD_WITH_DOT1Q, or COMBO.
Acceptable Frame Policy	Allows you to edit the acceptable frame policy applied to the selected port as Vlan Only or All.
PVID	Displays the port VLAN ID assigned to the port.
Default Prio	Allows you to edit the priority assigned to the port. Click on the value and select the desired value from the displayed options.
Admin Status	Allows you to edit the admin status of the port as 'Up' or 'Down'.
Enable MPLS	Allows you to enable or disable MPLS on the selected port by selecting/ un-selecting the check box.
BPDU Tunneling	Allows you to enable or disable BPDU Tunneling on the selected port by selecting/ un-selecting the check box.
Auto Negotiation	Allows you to enable or disable auto-negotiation on the selected port by selecting/ un-selecting the check box.
Enable LLDP	Allows you to enable or disable LLDP on the selected port by selecting/ un-selecting the check box.
Enable SyncE	Allows you to enable or disable syncE on the selected port by selecting/ un-selecting the check box.
MTU(Bytes)	Allows you to edit the maximum transmission unit on a port in bytes.

Editable GPON Port parameters

Parameter	Description

General
Fec Status	Enable or disable for forward error correction of frames egressing through the port.
PON Physical Reach	Edit the physical distance set between the OLT and the ONT device in the range 0 to 60 Km. All ONTs within the defined physical reach will be activated automatically. NOTE: Ensure the ONTs are installed in a way that there is a differential reach of less than 20 Km between two ONTs.
Admin State	Allows you to edit the admin status of the port as Activate or Deactivate.
Onu Discovery Mode	Edit the ONU discovery mode. Enable: The ONT will be detected automatically on the OLT (node) Disable: The ONT will not be automatically detected on the OLT (node)
Ether Type	Allows you to select the value from the options.

Editable PDH Ports parameters

Parameter	Description
CEM Function Support	Allows you to select CemEnable/CemDisable from drop down menu.
Framing Type	Allows you to select framed/unframed from the drop down menu.
Framing Application	Allows you to select framing application from the drop down menu.
Port Channelization	Allows you to select the port channelization to be used.