MVRP Commands

This section describes the commands you use to configure Multiple VLAN Registration Protocol (MVRP) information. MVRP allows the propagation of VLAN information from device to device. With MVRP, an access switch is manually configured with all the desired VLANs for the network, and all other switches on the network learn those VLANs dynamically.

mvrp (Global Config)

Use the mvrp command in Global Configuration mode to enable MVRP. MVRP must also be enabled on the individual interfaces.

• Default: disabled
• Format: mvrp
• Mode: Global Config

no mvrp (Global Config)

Use the no mvrp command in Global Configuration mode to disable MVRP.

• Format: no mvrp
• Mode: Global Config

mvrp periodic state machine

Use the mvrp periodic state machine command in Global Configuration mode to enable the MVRP periodic state machine.

• Default: disabled
• Format: mvrp periodic state machine
• Mode: Global Config

no mvrp periodic state machine

Use the no mvrp periodic state machine command in Global Configuration mode to disable the MVRP periodic state machine.

• Format: no mvrp periodic state machine
• Mode: Global Config

mvrp (Interface Config)

Use the mvrp command in Interface Configuration mode to enable MVRP mode on the interface. The port should be configured in trunk or general mode. MVRP can be enabled on physical interfaces or LAG interfaces. When configured on a LAG member port, MVRP is operationally disabled. Enabling MVRP on an interface automatically enabled dynamic VLAN creation.

• Default: disabled
• Format: mvrp
• Mode: Interface Config

no mvrp (Interface Config)

Use the no mvrp command in Interface Configuration mode to disable MVRP mode on the interface.

• Format: no mvrp
• Mode: Interface Config

clear mvrp

Use the clear mvrp command in Privileged EXEC mode to clear the MVRP statistics of one or all interfaces.

• Format: clear mvrp statistics [unit/slot/port | all]
• Mode: Privileged EXEC
• unit/slot/port: If used with the unit/slot/port parameter, the command clears MVRP statistics for the given interface.
• all: If the all parameter is specified, the command clears MVRP statistics for all the interfaces.

show mvrp

Use the show mvrp command in Privileged EXEC mode to display the status of the MVRP mode.

• Format: show mvrp [summary | interface [unit/slot/port | all]]
• Mode: Privileged EXEC

The display parameters for above command are:

• Summary: If the summary parameter is used, the command shows global MVRP information.
• Interface: If the interface is specified, the command shows MVRP mode information for that interface.
• All: If the all option is specified, the command shows a table containing MVRP global mode and the mode for all interfaces.

show mvrp statistics

Use the show mvrp statistics command in Privileged EXEC mode to display MVRP statistics.

• Format: show mvrp statistics [summary | unit/slot/port | all]
• Mode: Privileged EXEC

The display parameters for above command are:

• Summary: If used with the summary parameter, the command shows global MVRP statistics.
• Interface: If the interface is specified, the command shows MVRP statistics for that interface.
• All: If used with the all option, the command shows a table containing MVRP statistics for all interfaces on which MVRP is enabled.