Activate Tunnel

Perform the following steps to activate the selected tunnel(s):

1. Click Configuration > Layer 2 > Tunnels and click on Complete Tunnels. The Complete Tunnels page is displayed.
2. Select the tunnel(s) desired to be activated.

   NOTE: Tunnels in conflict or orphan state cannot be activated.

3. Click (Activate Tunnel). A confirmation window is displayed.
4. Click OK. Activation command sent successfully message is displayed.
5. Click OK. The tunnel is activated and is displayed under Active Tunnels tab.

NOTE: TJ5500 does not allow you to provision the PBT tunnel end points which are in different LAPS mode.