ONT Ethernet Port Loopback

Loopback at Ethernet port on ONT can be performed in TJ5500. Before starting the test, make sure ONT cards are properly discovered and TJ5500 WUI is showing all supported ONT Ethernet ports.

1. Go to Configuration > Access menu and click Manage ONTs option. Manage ONTs page is displayed.
2. Click on the desired row of ONT present. The set of tabs will be displayed below the ONT window.
3. Click on the ETH tab as shown in the following figure:

   

4. Click on Get loopback button for the desired row of ONT Ethernet port where loop back test needs to be run. The Trigger loopback window is displayed.

   

5. Select the duration as 1 minute/2 minutes/3 minutes from the drop down menu and click OK. View ONTEthPort Loopback Details window will be displayed.

   

Editing ONT Ethernet Ports Configuration

Perform the following steps to edit the ONT Ethernet ports configuration:

1. Go to Configuration > Access menu and click Manage ONTs option. Manage ONTs page is displayed.
2. Click on the desired row of ONT present. The set of tabs will be displayed below the ONT window.
3. Click on the ETH tab.
4. Click on the parameter for editing. The options are displayed.

   Only Mode, Auto-Negotiation and Flow Control parameters can be edited.

   

5. Select the desired option and click OK button.

   To undo the change in configuration, click Reset.

6. Click Save. The changes made in port configurations will be saved.