|
|
|
|
HCPSLine01 card supports 2xSTM-64 or 2x10GE interfaces. This card is supported in TJ1600 POTP (11 slot) chassis.
The mode(s) supported with HCPXCC03 and HCPXCC04 include:
The following figure shows the front panel view of HCPSLine01 card:
Power Specifications- HCPSLine01
Specification |
Range |
|---|---|
Input Voltage |
-48V DC |
Power consumption |
70W |
The visual indicators on the HCPSLine01 card include two LEDs, the Active and the Status LEDs.
Possible LED status and their significance- HCPSLine01
Card State |
Status LED |
Active LED |
Card initialization: State before the card initialize is complete on card insertion. |
Amber (Steady) |
Amber (Steady) |
Card in service: Initialization complete and card in service. |
Green (Steady) |
Green (Steady) |
Card mis-match: Node has already configured the slot with some other card. |
Amber |
Amber |
Card failed during boot up. |
Red |
Amber |
Card failed while in-service. |
Red |
Green |
Improper jack in of the card. |
Green(Blinking) |
Green(Blinking) |
Hard Reset: All devices reset, FPGAs cleared and reprogrammed. Goes to initializing state next. |
Amber |
Amber |
Soft Reset: Software is restarted, devices are reinitialized with provisioning. Goes to initializing state next. |
Green |
Green |
Early Ejector LED status: One ejector is removed(contains one ejector switch in right) |
OFF |
Amber |
XFP Port Transmitter (Tx) and Receiver (Rx) LED Status - HCPSLine01
State |
Rx LED |
Tx LED |
|---|---|---|
XFP present (Laser on) with Rx LOS |
Amber |
Green |
XFP present (Laser off) with Rx LOS |
Amber |
Off |
XFP present (Laser on) with no Rx LOS |
Green |
Green |
XFP present (Laser off) with no Rx LOS |
Green |
Off |
Card failed while in-service |
Red |
Green |
XFP missing (LOS detected), Laser On (attempted) |
Amber |
Green |
XFP missing (LOS masked since SFP missing and set to Admin_down), Laser Off (attempted) |
Amber |
Off |
XFP failed (whether provisioned, unprovisioned, LOS or no LOS) |
Red |
Red |
The LASER types supported is STM-64: S-64.1, S-64.2a, S-64.2b, L-64.1 and L-64.2
OPTICAL SAFETY: Do not stare or look directly into the optical connector output beam, as this can cause irreparable damage to your eyes and even loss of eye sight.
HCPSLine01 card processes the received STM-64 frame for all alarms and performance monitoring signals. HCPSLine01 card supports the following functional features: