HCPSLine25 is a single slot aggregated card. It supports SFP+ interfaces. This card is supported in TJ1600 Type-11SR, TJ1600 Type-6SR and TJ1600 Type-2SR.
The mode supported with HCPXCC03, HCPXCC04, OSMC01 and OAMC include:
The following figure shows the front panel view of HCPSLine25 card:
Specification |
Range |
---|---|
Input Voltage |
-48V DC |
Maximum Power consumption |
105W |
The visual indicators on the HCPSLine25 card include two LEDs, the Active and the Status LEDs.
Card State |
Status LED |
Active LED |
---|---|---|
Card initialization: State before the card initialize is complete on card insertion. |
Amber (Steady) |
Amber (Steady) |
Card in service: Initialization complete and card in service. |
Green (Steady) |
Green (Steady) |
Card mis-match: Node has already configured the slot with some other card. |
Amber |
Amber |
Card failed during boot up. |
Red |
Amber |
Card failed while in-service. |
Red |
Green |
Improper jack-in of the card. |
Green (Blinking) |
Green (Blinking) |
Hard Reset: All devices reset, FPGAs cleared and reprogrammed. Goes to initializing state next. |
Amber |
Amber |
Soft Reset: Software is restarted, devices are reinitialized with provisioning. Goes to initializing state next. |
Green |
Green |
State |
Rx LED |
Tx LED |
---|---|---|
SFP+ present (Laser on) with Rx LOS |
Amber |
Green |
SFP+ present (Laser off) with Rx LOS |
Amber |
Off |
SFP+ present (Laser on) with no Rx LOS |
Green |
Green |
SFP+ present (Laser off) with no Rx LOS |
Green |
Off |
Card failed while in-service |
Red |
Green |
SFP+ missing (LOS detected), Laser On (attempted) |
Amber |
Green |
SFP+ missing (LOS masked since SFP missing and set to Admin_down), Laser Off (attempted) |
Amber |
Off |
SFP+ failed (whether provisioned, unprovisioned, LOS or no LOS) |
Red |
Red |
Optics |
Rate |
Reach (Km)* |
---|---|---|
10GE SFP+ |
10Gbps |
10km |
S64.2b SFP+ |
STM-64 |
40km |
P1L1-2D2 SFP+ |
STM-64/OTU2 |
80km |
HCPSLine25 card supports the following functional features: