Create circuits using selected circuits

Perform the following steps to create a circuit over the selected circuits:

1. Click Click Configuration > Layer 1 > Circuits and click on Manage Circuits. The Manage Circuits page is displayed.
2. Click (Select Circuits). The check box against each circuits is enabled on the Manage Circuits page.
3. Select the desired circuits by clicking the check box against that circuit.

   To undo the check box selection on one circuit de-select the check box. To undo the selection of all the selected circuits click on (Clear Selection).

4. After selection, right-click and select Create Circuit using Selected Circuits from the menu options. The Create Circuit from Topology View window is displayed.
5. Follow the steps mentioned in Create circuits from Topology View menu. In Create Circuit from Topology View window, under Source and Destination Information, IP addresses of only those nodes on which the selected circuits are present will be displayed in the drop down list.