HCPSLine01 card supports 2xSTM-64 or 2x10GE interfaces. HCPSLine01 card processes the received STM-64 frame for all alarms and performance monitoring signals.
HCPSLine01 card supports the following functional features:
The mode(s) supported with HCPXCC03 and HCPXCC04 include:
Front panel
The following figure shows the front panel view of HCPSLine01 card:
Power Specifications
Specification |
Range |
---|---|
Input Voltage |
-48V DC |
Maximum Power consumption |
80W |
Visual indicator details
HCPSLine01 card has two LEDs - the Sts (Status) LED indicate the status of the card and the Act (Active) LED indicates whether the card is active or not.
Card State |
Status LED |
Active LED |
Card initialization: State before the card initialize is complete on card insertion. |
Amber (Steady) |
Amber (Steady) |
Card in service: Initialization complete and card in service. |
Green (Steady) |
Green (Steady) |
Card mis-match: Node has already configured the slot with some other card. |
Amber |
Amber |
Card failed during boot up. |
Red |
Amber |
Card failed while in-service. |
Red |
Green |
Improper jack in of the card. |
Green(Blinking) |
Green(Blinking) |
Hard Reset: All devices reset, FPGAs cleared and reprogrammed. Goes to initializing state next. |
Amber |
Amber |
Soft Reset: Software is restarted, devices are reinitialized with provisioning. Goes to initializing state next. |
Green |
Green |
Early Ejector LED status: One ejector is removed(contains one ejector switch in right) |
OFF |
Amber |
State |
Rx LED |
Tx LED |
---|---|---|
XFP present (LASER on) with Rx LOS |
Amber |
Green |
XFP present (LASER off) with Rx LOS |
Amber |
Off |
XFP present (LASER on) with no Rx LOS |
Green |
Green |
XFP present (LASER off) with no Rx LOS |
Green |
Off |
Card failed while in-service |
Red |
Green |
XFP missing (LOS detected), LASER On (attempted) |
Amber |
Green |
XFP missing (LOS masked since SFP missing and set to Admin_down), LASER Off (attempted) |
Amber |
Off |
XFP failed (whether provisioned, unprovisioned, LOS or no LOS) |
Red |
Red |
LASER types
The LASER types supported is STM-64: S64.1, S64.2a, S64.2b, L64.1 and L64.2.