HCPSLine26 is a single slot card providing interface to 20x10G client ports and 1x100G/200G software configurable optical line port. The coherent optics on the card is included as part of the card and is not pluggable.
The line rate of HCPSLine26 is software configurable to either 100G or 200G. 100G line rate is over QPSK modulation while 200G line-rate is supported on both 8-QAM and 16-QAM modulations.
HCPSLine26 card supports the following functional features:
The mode supported with HCPXCC03, HCPXCC04, OSMC01 and OAMC include:
20x10G to 2 OTU4 Muxponder
NOTE: If a port “n” is configured as 16GFC then immediate next port (n+1) cannot be used for any other client ports.
If a port “m” is configured as 32GFC then next 3 continuous ports (m+1, m+2, and m+3) cannot be used for any other client ports.
The following figure shows the front panel view of the HCPSLine26 card.
Power specifications
Specification |
Range |
---|---|
Input Voltage |
-48V |
Maximum Power consumption |
145W |
Visual indicator details
The visual indicators on the HCPSLine26 card has two LEDs - the Sts (Status) LED indicate the status of the card and the Act (Active) LED indicates whether the card is active or not.
Card State |
Status LED |
Active LED |
---|---|---|
Card initialization: State before the card initialize is complete on card insertion. |
Amber (Steady) |
Amber (Steady) |
Card in service: Initialization complete and card in service. |
Green (Steady) |
Green (Steady) |
Card mis-match: Node has already configured the slot with some other card. |
Amber |
Amber |
Card failed during boot up. |
Red |
Amber |
Card failed while in-service. |
Red |
Green |
Improper jack-in of the card. |
Green (Blinking) |
Green (Blinking) |
Hard Reset: All devices reset, FPGAs cleared and reprogrammed. Goes to initializing state next. |
Amber |
Amber |
Soft Reset: Software is restarted, devices are reinitialized with provisioning. Goes to initializing state next. |
Green |
Green |
Early Ejector LED status: One ejector is removed (contains one ejector switch in right) |
OFF |
Amber |
State |
Rx LED |
Tx LED |
---|---|---|
LASER on with Rx LOS. |
Amber |
Green |
LASER off with Rx LOS |
Amber |
Off |
LASER on with no Rx LOS. |
Green |
Green |
LASER off with no Rx LOS. |
Green |
Off |
LASER types
Optics |
Rate |
Reach* |
|
---|---|---|---|
10GE SFP+ |
10Gbps/Lan PHY |
10km |
|
S64.2b SFP+ |
STM-64/Wan PHY |
40km |
|
P1L1-2D2 SFP+ |
STM-64/OTU2 |
80km |
|
Onboard optics |
Configurable 100G/200G |
100G- 2500Km (amplified) 200G- 1200Km (amplified) |
|
* For G.652 fiber under Standard link conditions |